Joined: 04 Jan 2004, 00:28
Posts: 280
Location: Tucson AZ USA
|
|
Spent the Afternoon "doodling" with a couple pieces of 3DModelclub.com clipart. The power of this stuff is the ability to modify it in ArtCAM very quickly.
This ring was ornamented with just the two pieces of clipart shown on the right. In the 3D clipart dialog, don't forget that you can rotate copies and paste along a curve. That and the relief envelope tool were the principal tools used to slap the ornamentation on an otherwise simple shank.
| Attachments: |
leaf ring.jpg [ 204.96 KiB | Viewed 211 times ]
|
_________________
Randy Hays
Artisan CNC
randy.h@artisancnc.com
520 907-5649
|
|
